Adding floppy disk support to CircuitPython, step 2
OK now that we've gotten the motor up and running, and the drive selected in step 1 - we know our wiring is correct. step 2 is getting data out! unlike almost all protocols we're used to, there's no clock pin on floppy data. it comes out in MFM format (at least, this floppy disk format does) which means we get a series of ~500kHz open-drain pulses with short negative widths, and varying positive widths that indicate flux transitions. now the *proper* thing to do here is use a PLL to sync up with the pulses since the motor speed can vary a few %, then convert the pulse widths to bits of data…
The skinny
The skinny isn't ready yet — notes appear once the transcript is processed.