Latest / Red Talks / Episode 14: Predictive Maintenance: The Truth About Ultrasound and Partial Discharge
Transcript
- 0:06SPEAKER_01: I like to see sales guys who uh who lie less.
- 0:10SPEAKER_01: You know, one of the big ones that I absolutely hate is when people say that ultrasound can detect partial discharge.
- 0:18SPEAKER_01: It's not a lie, but it's not the whole truth in the statement.
- 0:23SPEAKER_01: Partial discharge has two kinds of uh like you split it in two.
- 0:29SPEAKER_01: There's surface faults and subsurface faults.
- 0:31SPEAKER_01: Surface faults are faults that are along the surface and they emit an audible signal that can be detected with ultrasound.
- 0:39SPEAKER_01: Arcing, tracking, corona.
- 0:43SPEAKER_01: That is not the full scope of what partial discharge is.
- 0:48SPEAKER_01: Partial discharge can also be subsurface faults.
- 0:53SPEAKER_01: Subsurface faults don't make sound because they're below the surface.
- 0:59SPEAKER_01: A subsurface partial discharge fault is that you've got, you know, let's just give a wire for example.
- 1:04SPEAKER_01: You've got a wire, there's a conductor running through the middle, and you have some kind of void in the insulation that's there's a manufacturing defect, maybe it was pulled in wrong and it nicked or what nicked the uh insulation, and now the rating of that cable has gone down dramatically.
- 1:18SPEAKER_01: So you're getting tiny little internal sparks that are jumping from the conductor to the void, and that void grows, grows, grows, grows, grows.
- 1:26SPEAKER_01: One day, bang, the gear goes out.
- 1:29SPEAKER_01: There is no ultrasound device in the world that is ever going to detect that because it's not a surface fault.
- 1:35SPEAKER_01: The modes of inspection that will detect that are TEV, transient earth voltage.
- 1:42SPEAKER_01: I'll give the example of a hose because partial discharge is kind of hard to visualize.
- 1:46SPEAKER_01: But you've got a hose, it's got a tiny little hole in it, right?
- 1:49SPEAKER_01: And you turn on that hose.
- 1:51SPEAKER_01: There's no real pressure in that hose, so you never know there's a leak in it.
- 1:55SPEAKER_01: And one day you crank the pressure up on that hose, and now that tiny little pinhole is spraying water everywhere.
- 2:03SPEAKER_01: It was there, but there wasn't enough to show it was there.
- 2:08SPEAKER_01: PD is similar, and I know there are some PD purists who will hate this example, but it's it's all about simplicity and visualising what I'm talking about.
- 2:18SPEAKER_01: That void in the insulation of a piece of wire is like a pinhole in a hose.
- 2:24SPEAKER_01: If there ain't enough voltage running through that wire, you'll never know it was there.
- 2:28SPEAKER_01: If you hit 5 kV and above, depending on you know the rating of the occurrence, but but subsurface partial discharge is not accepted as being there below 5 kV.
- 2:43SPEAKER_01: And then one day it blows up.
- 2:47SPEAKER_01: The TEV is transient Earth voltage, is detecting those electrons that are dripping out the wire.
- 2:54SPEAKER_01: Ultrasound don't pick that up.
- 2:56SPEAKER_01: Let's talk about gas insulated switch gear.
- 2:58SPEAKER_01: Gas insulated switch gear, it's tough to do ultrasound on because it's insulated with gas.
- 3:06SPEAKER_01: It can still have partial discharge faults.
- 3:09SPEAKER_01: Partial discharge there, you'd have to use something called a UHF or an ultra high frequency transform that you stick on the side of equipment.
- 3:17SPEAKER_01: This block can detect the PD fault inside of a gas insulated switch.
- 3:22SPEAKER_01: And then uh the final mode is UA um HFCT, high frequency current transform.
- 3:27SPEAKER_01: It's a little CT clamp that you put over a wire and it tells you if PD is present in that wire.
- 3:32SPEAKER_01: Put it in ground it, tell you if it's present somewhere in that system.
- 3:36SPEAKER_01: Again, ultrasound cannot detect that.
- 3:39SPEAKER_01: So when manufacturers go in there and they say, ultrasound detects PD, they're not lying.
- 3:46SPEAKER_01: They're not telling the whole truth.
- 3:48SPEAKER_01: And that makes us all look bad.
- 3:50SPEAKER_01: So I'd like to see people accepting that we're not talking crap.
- 3:56SPEAKER_00: And then the sales guys not talking crap.comslashabout.